YUNO plastic surgery

YUNO Magazine

Expert plastic surgery insights from YUNO Plastic Surgery in Gangnam, Seoul

YUNO Magazine › Plastic Surgery Guide
Plastic Surgery Guide

Alar Reduction: What to Know About the Structure and Methods Before Surgery

Alar Reduction: What to Know About the Structure and Methods Before Surgery

Yuno Plastic Surgery Magazine · Published September 2026 · Medically reviewed

Key Takeaways

  • Wide-looking nostril wings (alae) fall into types: alae that flare sideways, a wide nostril floor, and a bulbous nose tip.
  • Depending on the cause, alar reduction is chosen from lateral excision, medial excision, a combination of the two, or a non-incisional method.
  • If you have a bulbous nose with a round, blunt tip, alar reduction alone may not be enough, so you should check whether nose tip correction is also needed.
  • The incision lines are placed along natural borders, but reducing too much can make the nostril shape look awkward, so the amount of reduction is decided carefully.

Many people are bothered when they look at a front-facing photo and their nostril wings look wide, or when the wings spread sideways as they smile.

"If I only reduce the alae, will my nose look smaller?" "Will I have a scar?" "I have a bulbous nose. Will alar reduction be enough?"

To start with the conclusion: the reason the alae look wide differs from person to person, so you need to identify the type first in order to choose a suitable method.

Alar reduction is surgery that adjusts the horizontal proportion of the lower nose by reducing the width of widely flaring alae or of the nostril floor. Depending on the cause, lateral excision, medial excision, combined excision, or a non-incisional method can be considered.

The approach differs when the alae themselves flare sideways, when the nostril floor is wide, and when a blunt nose tip makes the whole lower nose look wide.

This article goes in order through the structure of the alae, the types of wide-looking alae, the surgical methods, and the recovery process.

What Is the Structure of the Alae?

The alae are the wing-shaped areas that wrap around both sides of the nostrils, and they are also called the nasal wings.

The shape of the alae is determined by the skin, the soft tissue beneath it, and the structures connected to the nose tip. So you need to check not only the size and thickness of the alae themselves, but also where they connect to the face and the width of the nostril floor.

Add the width of the nostril floor and the shape of the nose tip, and these decide the width of the lower nose as seen from the front.

What Are the Types of Wide-Looking Alae?

Below are the typical types of wide-looking alae. In reality, two or more types often occur together.

TypeWhat It Looks LikeMethod Mainly Considered
Alae that flare sidewaysThe alae are round and flare outward, and spread more when you smileLateral excision
Wide nostril floorThe alae do not flare much, but the nostril openings look wide and largeMedial excision
Both togetherThe alae flare and the nostrils are wide, so the whole lower nose looks largeCombined lateral + medial excision
Bulbous nose tip (bulbous nose)The nose tip is wide and round, so the alae look wide tooTip cartilage rhinoplasty (with alar reduction if needed)

What Methods Are Used for Alar Reduction?

The surgical method for alar reduction differs depending on which area is wide and how much needs to be reduced.

Lateral Excision

Lateral excision reduces part of the outer skin and tissue along the border where the alae meet the cheek, to improve alar flare. It is mainly considered when the alae flare out widely to the side.

Medial Excision

Medial excision adjusts the inner entrance and floor of the nostrils to reduce the horizontal width of the nostrils. The position and extent of the incision can vary with the nostril shape and the amount of correction needed.

Combined Excision

When both alar flare and nostril width need to be reduced, combined excision, which adjusts the outer and inner areas together, can be considered. Because the range of correction is wider, it is important to check the overall facial proportions and left-right symmetry together.

Non-Incisional Alar Reduction

Non-incisional alar reduction uses thread to draw both alae inward and fix them in place, without cutting skin. Compared with incisional methods, the range it can correct may be limited, so whether to apply it is decided after checking the degree of alar flare and the tissue condition.

Are There Cases Alar Reduction Alone Does Not Solve?

Yes. When the reason the lower nose looks wide is not the alae themselves, alar reduction alone may not give the change you want.

A bulbous nose, with a blunt, wide tip, can be caused by the shape or position of the alar cartilage. In that case, reducing only the alae can leave the round form of the tip as it is, so you need to check whether tip cartilage rhinoplasty is also needed.

The alae can also look relatively wide depending on the height of the nasal bridge and tip and the overall proportions of the nose. If other nose surgery is planned together, it is important to decide the amount of alar correction by considering the changes in the bridge, tip, and alae together.

What Should I Check Before Surgery?

With alar reduction, even a small change in the amount of correction can affect the front-facing impression and the shape of the nostrils, so evaluation before surgery is important.

  • Were you told whether your alae are the flared type, the wide-nostril type, or a nose tip issue?
  • Was the amount to reduce decided together with overall facial proportions, such as the distance between the eyes, lip width, and philtrum?
  • Was the shape of your alae checked when smiling as well as at rest?
  • Did you tell the team if your scars tend to turn red or thick, and whether you have had previous nose surgery?

Reducing the alae too much can make the nostrils look narrow or unnatural, and functional discomfort may also occur. Because removed tissue is hard to restore, the amount of correction should be decided by considering both facial proportions and breathing function.

What About Scars and Recovery?

The incision lines are planned along natural borders, such as the crease between the alae and cheek or the inside of the nostrils, so that they are less noticeable.

After surgery, swelling, bruising, and redness at the incision site can appear. The timing of suture removal and how quickly swelling goes down can vary with the extent of surgery and individual recovery.

During recovery, it is best not to rub or irritate the incision site hard. Care methods such as sun protection, scar ointment, and taping can differ depending on the condition of the surgical site, so follow the guidance of your medical team.

FAQ | Frequently Asked Questions About Alar Reduction

Can alar reduction be done together with bridge or nose tip surgery?

It is often done together. When the bridge and tip change, how narrow the alae look also changes, so it is better to decide how much to reduce them by looking at the overall proportions together.

Will the scar from alar reduction be very visible?

The incision lines are often placed along natural borders, such as the crease where the alae meet the cheek or the inside of the nostrils. They may look red early on but often fade over several months, and this differs depending on skin type and how you scar.

Is non-incisional alar reduction effective?

This method gathers and ties the alae together with thread without cutting skin, and it can be considered when the flare is mild. However, there is a limit to how much width it can reduce and it may loosen somewhat over time, so an incisional method may be needed if the alae themselves are large or thick.

If the alae are reduced a lot, won't breathing be uncomfortable?

If the nostril entrance is reduced too much, the nostril shape can look unnatural or you may feel stuffy. That is why it is important to decide the amount of reduction by considering both facial proportions and function.

Can the sensation of the alae change after surgery?

Sensation around the surgical site may become temporarily dull or sensitive. In most cases it gradually returns during recovery, but the speed of recovery differs from person to person.

Check the Structure First, Then Decide the Method

Alar reduction corrects a relatively small area, but it is surgery that can affect the width of the nose seen from the front and the overall facial impression.

The method you need differs depending on whether the alae look wide because of alar flare, the width of the nostril floor, or the shape of the nose tip. Even with the same method, the shape of the nostrils and the overall impression can change depending on the amount of correction.

It is important to first check the current structure of the nose and overall facial proportions, and then adjust only the range needed, considering both function and shape.

Rather than deciding on the alar reduction method first, it is better to check the structure of the alae, nostril floor, and nose tip together through a consultation and then make the surgical plan.


Notice

This content is provided for general medical information and does not replace diagnosis or treatment for an individual condition. Please decide on an accurate diagnosis and surgical method through a consultation with your medical team.

All surgeries and procedures can involve side effects and complications such as swelling, bruising, bleeding, infection, scarring, asymmetry, over-correction or under-correction, changes in sensation, and the possibility of revision surgery, and the degree and recovery process vary from person to person.

This content is written to provide medical information, not as a personal treatment experience or patient review.

Yuno Plastic Surgery · Medically reviewed

Like 0

Medically reviewed by Dr. Kim Shin Young, Head Surgeon at YUNO Plastic Surgery, Seoul · Last reviewed: November 2026